This data release contains water chemistry data used to create a total dissolved solids (TDS) map of the Winterburn hydrostratigraphic unit (HSU). The data were acquired from publicly available formation water chemistry data from oil and gas well drillstem tests (DSTs) and production fluids.
Data have been processed, relevant records selected, and outliers removed to compile this dataset.
The mid-point of the sampled interval is a calculated value, and its accuracy is dependent on the accuracy of the measured depths and elevations provided in the well header. These values are somewhat inconsistent for the water wells because many of them are not surveyed. For the oil and gas wells, the well elevations and locations are surveyed, so precision will be to the same number of significant digits as provided by the data source, even though there may be considerable uncertainty as to where the sample actually came from.
The location of the sampled interval in oil and gas wells may be accurate to within millimetres in accordance with surveying standards at the time of drilling.
Data containing chemical analyses were obtained from formation water analyses from DSTs and production fluid samples from oil and gas wells.
Process steps for selection of chemical analysis from oil and gas wells:
1. Records that have values for interval top and bottom were selected;
2. The screen interval was constrained to less than or equal to 50 m;
3. Acceptable charge balance error was constrained within ±10%;
4. Samples labelled as “incomplete analysis" were removed;
5. Records were allocated to the Winterburn HSU based on the depth information of the tested interval;
6. Records with tested intervals straddling the top or bottom of the Winterburn HSU were excluded, unless they were from wells in data-poor areas and it was verified that less than 30% of the tested interval extended into the formation directly above or below the HSU, but not into any other formation.
7. In case of collocated data, the most representative sample was selected, or averaging of TDS values was done;
8. The concentration of total dissolved solids (TDS) was determined either by summing the concentration of major constituents (if available), or by using the TDS values as reported in the source dataset (if major constituents were not available);
9. The remaining formation water analyses were subjected to additional screening to identify potential contamination of the formation water by drilling fluids such as acid water, corrosion inhibitors, mud filtrates, and alcohols;
The final dataset includes only those records that were used in the production of the final TDS surface.
Details about the screening process can be found in the following reference: Jensen, G.K.S., Rostron, B., Palombi, D., and Melnik, A. (2013): Saskatchewan Phanerozoic Fluids and Petroleum Systems project: hydrogeological mapping framework; in Summary of Investigations 2013, Volume 1, Saskatchewan Geological Survey, Sask. Ministry of the Economy, Misc. Rep. 2013-4.1, Paper A5, 10p. URL http://publications.gov.sk.ca/details.cfm?p=80100 [October 2018]